Drager bump test station manual

The X-dock is available in a wide variety of versions. The X-dock 5300 includes a master station including a module for a gas detection instrument from the X-am 1/2/5x00 or Pac family. It is immediately ready to use. The X-dock 6300 and 6600 versions can be configured freely. They consist of a master station and can be expanded with up to 10 Dräger Bump Test Station. Calibration Gas-20PPM Chlorine Balance Air (34L) Dräger RPS 3500 Rescue Device. Easy to use, stand-alone and portable. With the Bump Test Station, functionality tests of gas detection and warning devices can be carried out easily and quickly. KEY FEATURES. With Dräger Bump Test Station the unit can be configured to automatically start the bump test without pressing any key. In this case the manual start of the bump test is deactivated. 3 - To activate the bump test press [OK]. - Open the regulator valve to let test gas flow over the sensor. - Prepare a Dräger test gas cylinder with 0.5 l/min and a gas concentration higher than the alarm threshold to be tested. - Connect Dräger Pac 7000 and the test gas cylinder to the calibration adapter or connect the device to the Dräger Bump Test Station. - To enter the bump test mode, press the [+] 3 times within 3 seconds. 4.3 Performing a "bump test" with gas - Prepare a Dräger test gas cylinder with 0.5 l/min and a gas concentration higher than the alarm threshold to be tested. calibration adapter or connect Dräger Pac 7000 to the Dräger Bump Test Station. - To enter the bump test mode, press the [+] 3 times within 3 seconds. The instrument beeps twice The instrument is set to the bump test function, see section 3.4 on page 13 The instrument is set to the fresh air calibration function, see section 5.2 on page 18 The instrument is set to the 1-button calibration/ adjustment function, see section 5.3 on page 19 The instrument is set to the single gas calibration function, see section 5.3.1 on The device is set to function test with gas (bump test), refer to page 32 The device is set to the fresh air calibration function, refer to page 38 The device is set to the 1-button calibration function, refer to page 40 The device is set to the single gas calibration function, refer to page 42 The function for password entry is active, refer Risk to health! Test gas must not be inhaled. Observe the hazard warnings of the relevant safety data sheets. - Insert the Dräger Pac 3500/5500 and connect the test gas cylinder to the in-let (back most) nipple on the calibration adapter or to the Dräger Bump Test Station. - To enter the bump test mode manually press the [+] 3 times within 5.3 Devices for calibration and functional testing 281 5.4 Manual bump test 282 5.5 The Drager Bump Test Station 282 5.6 Drager X-dock - more than just a test station 283 5.13 Drager CC-Vision Basic 296 . Open the catalog to page 6. 1 Introduction Dear readers, Sensors and instruments in the portfolio of the Dräger portable gas detection when carried out with standard gases. Thus, the bump test has been further optimised as compared to the Dräger Bump Test Station.1 All Dräger test gas cylinders are already stored in the database - entering the part number will automatically fill in the fields required for the gas configuration. This eliminates the need for manual data entry. Prerequisites for the manual bump test: The gas detector is switched on. A suitable test gas cylinder is available, e.g. a test gas cylinder (order no.