Clinitek status + procedure manual

3.1 Introduction Refer to Section 1 "Introduction" and Section 3 "Start-Up Wizard" of the Operators Manual for the proper installation and set up of the CLINITEK® Status Analyzer. 1 Unpack the instrument from the shipping packaging. 2 Remove package tape from the front of the instrument, table shutter. 3 Insert test table with table The information in this manual was correct at the time of printing. However, Siemens Diagnostics continues to improve products and reserves the right to change specifications, equipment, and maintenance procedures at any time without notice. If the Clinitek Advantus analyzer is used in a manner differently than specified Clinitek Status+ Connect Self-Study Packet Revised 04/2019 . Repeat test using the proper procedure. E50 . Incorrect Strip Type or Tilted Strip -Dipstick other than Multistix 10SG used. -Repeat test, ensuring correct placement of strip. E25, E64, E65 . Failure of Automatic Refer to your Clinitek Status analyser Operator's Manual for detailed cleaning and maintenance instructions. PROCEDURE STEPWISE 1. At the main Select screen, touch Cassette Test. The Operator ID screen will appear. 2. If you were the last operator to enter an ID on the analyzer, touch Last Operator. The Patient Information screen will appear. 3. Using the keyboard, enter the patient name, then touch enter. Touch the start button to access the Prepare test screen. Once start is pressed, you have 8 seconds to prepare the test. Fill the pipette included with the cassette with urine. Add the entire contents from the pipette into the sample well of the cassette. Modified GC Screen 6 month and Annual Competency Documentation. Modified GC Screen Quiz and Observation Checklist. Modified GC Screen Alternate Proficiency Result Form. GEM 3500 Procedure POCT. GEM 5000 Competency Documentation-6 month and annual POCT. GEM 5000 CPET Quiz POCT. GEM 5000 Operator Training Checklist POCT. Or in the Siemens Operator Manual. However, if you have any queries please don't. User and patient ID must be entered for all tests 4. The department must be enrolled in an external quality control scheme. Feb 14, 2012 The Clinitek Status Analyzer allows us to perform a CLIA-waived semi-quantitative urinalysis. Dept. of Pathology & Laboratory Medicine Page 2 of 12 Clinitek Point of Care Urinalysis Testing.doc rev. 06/09 Departmental Manual Key Contact: Point of Care Coordinator OPERATORS: Registered Nurses and emergency room technicians who are properly trained on the Clinitek Status testing system perform the procedure. The best temperature for using the instrument is between 22°C and 26°C (72°F and 79°F). Do not place the analyzer outside or near windows, ovens, hot plates, or radiators. 4 Plugging Analyzer In Plug the appropriate end of the power cord into the power inlet socket located on the rear of the Clinitek Status analyzer. The CLINITEK Status Connect System performs a "self-test" and calibration each time you power on the system. The analyzer performs an automatic calibration each time you run a test. The white calibration bar (on the test table) provides NIST traceable calibration. 6.3 Entering Urine Color and Clarity During Test Cycle (in Full Test or 3.1 Introduction. Refer to Section 1 "Introduction" and Section 3 "Start-Up Wizard" of the Operators. Manual for the proper installation and set up of the CLINITEK ® Status Analyzer.. 1 Unpack the instrument from the shipping packaging.