Care awning manual override

Turn the handle clockwise until the awning is retracted. 4. Reinstall the plug Current Configuration 1. Remove the right outer endcap and save. 2. Insert a 3/8" socket drive extension and handle into the square drive hole inside the inner end cap. 3. Turn the handle clockwise until the awning is retracted. 4. Reinstall the outer cap. If this occurs, wait approximately 15 minutes to allow the motor to cool then operate the awning in normal fashion. 2. The awning seems to extend and retract slowly. Normal operation time is 28-35 seconds to extend or retract. If the power supply is on the low side of the acceptable voltage range (10VDC-14VDC) the awning will move slower. 3. Insert the hex key into the manual override on the awning. For the top access, it will be necessary to locate the hex by feel; it is not visible with the key inserted in the hole. 3. Operate the drill in the forward (clockwise) direction to close the awning. Reverse the drill to open the awning. Manual Override 5 Solera Power Awning Assembly 6 Solera Power Awning Components 7-14 Notes 15. Rev: 06.05.18 Page 3 CCD-0001369 Operation Fabric Care If the awning is rolled up while wet, roll it out and let it dry as soon as conditions allow before rolling it up again. This will help prevent the formation of mildew and add greatly to the The awning will roll out evenly with the switch, but doesn't want to come back in, except an inch or two at a time. Just to make sure that the motor wasn't jambed, I rolled it out a ways and popped the cover off the right end of the awning and used a 3/8 socket to crank it back in. It rolled in smoothly. interrupt the awning retraction, press the stop button. The awning will stop. To Close the Awning: Press and release the retract button. The awning will close completely. To interrupt the awning retraction, press the stop button. The awning will stop. When the awning is in the retracted (rolled up) position, press the power MANUAL OVERRIDE If power to the vehicle is not available, the awning can be safely retracted using the manual override located on the idler (right) end of the case. NOTE: This procedure cannot be used to extend the awning. 1. Remove the plug from the right endcap and save. 2. 12V Motorized Lateral Arm Box Awning RV with Carefree's BT12 Wireless Awning Control System Using Bluetooth® wireless technology Before operating the awning, carefully review the Owner's Manual. The manual contains important safety information, detailed operating instructions, common maintenance and other useful information. TABLE OF CONTENTS JL-BRAND 266149 RV Power Awning Replacement Universal Motor Compatible with Solera Power Awnings Including Flat, pitched and Short Assemblies, 12-Volt DC and 75-RPM 4.7 out of 5 stars 383 4 offers from $50.56 This awning (hereinafter referred to as "awning," or "product") is designed and intended for use on RVs with straight sides. For curved sides, please see the separate Hardware List in the Dealer Service Manual for the appropriate model. Use these instructions to ensure correct operation of product. Remove the canopy retaining screws in the awning rail. 2. Partially extend the awning. 3. Place stop blocks between the arm rollers and arm stops on both arms. Blocks should be 5"-6" in length. 4. Extend the awning. The arms will stop with the stop blocks in place. Check that the blocks are firmly seated between the rollers and arm stops. 5. Remove the canopy retaining screws in the awn